This adds support for a BeagleBone Black platform to the sage lab. We
test with both the legacy network stack and lwIP.
Signed-off-by: Tom Rini <trini@konsulko.com>
Add snmp and rsync to the normal docker image. While these tools are
only required for the lab on sage, I think it's a small enough addition
to be worth always including at this point. A higher level TODO I think
may be to see if we can / should split the resulting container up, or
if there's host tooling we can remove at a later step, after building
all the software we require.
Signed-off-by: Tom Rini <trini@konsulko.com>
This adds the Pine64+ platform to the sage lab, for both legacy and lwIP
networking stacks. In order to build this platform we need to copy
certain files that were built in the container to /tmp and then set
BINMAN_INDIRS to /tmp in order to find them when building.
For now, we disable the test_net_pxe_boot_config test on lwIP as it
leads to a crash that needs to be investigated.
Signed-off-by: Tom Rini <trini@konsulko.com>
This is the Gitlab side of adding support for the board lab connected to
the "konsulko-sage" runner. On the software side, this lab uses only
upstream labgrid. On the hardware side, each device under test is
connected to its own exporter (typically a Raspberry Pi 4) that must be
turned on (and cleanly turned off) as part of a given test cycle.
Add support for testing on a SolidRun Hummingboard 2 (imx6), Raspberry
Pi 3 and Raspberry Pi 4. In all cases, we enable additional options to
run more tests on the board. As we have some networking tests, we test
both the legacy network stack and lwIP. In the case of Pi platforms, we
test all of 32bit configuration, plain configuration and rpi_arm64, and
again with and without lwIP.
Signed-off-by: Tom Rini <trini@konsulko.com>
