6d04828b45
Support for using "u-boot,dm-..." rather than "bootph-..." has been deprecated since February 2023. Any platforms using this have had a console message saying to migrate by 2023.07. Go and remove all support here now, for the v2026.01 release. The results of this change that aren't clear from the above are that we still have a checkpatch.pl error message, and document in doc/develop/spl.rst that they have been migrated since 2023. We also change the key2dtsi.py tool to use the correct bootph phase rather than the legacy phase. Signed-off-by: Tom Rini <trini@konsulko.com>
114 lines
2.8 KiB
Plaintext
114 lines
2.8 KiB
Plaintext
CONFIG_ARM=y
|
|
CONFIG_SKIP_LOWLEVEL_INIT=y
|
|
CONFIG_COUNTER_FREQUENCY=24000000
|
|
CONFIG_ARCH_ROCKCHIP=y
|
|
CONFIG_SPL_GPIO=y
|
|
CONFIG_SF_DEFAULT_SPEED=24000000
|
|
CONFIG_SF_DEFAULT_MODE=0x2000
|
|
CONFIG_DEFAULT_DEVICE_TREE="rockchip/rk3588-jaguar"
|
|
CONFIG_ROCKCHIP_RK3588=y
|
|
CONFIG_ROCKCHIP_BOOT_MODE_REG=0x0
|
|
CONFIG_SPL_SERIAL=y
|
|
CONFIG_TARGET_JAGUAR_RK3588=y
|
|
CONFIG_SYS_LOAD_ADDR=0xc00800
|
|
CONFIG_SF_DEFAULT_BUS=5
|
|
CONFIG_DEBUG_UART_BASE=0xfeb50000
|
|
CONFIG_DEBUG_UART_CLOCK=24000000
|
|
CONFIG_PCI=y
|
|
CONFIG_DEBUG_UART=y
|
|
CONFIG_FIT=y
|
|
CONFIG_FIT_VERBOSE=y
|
|
CONFIG_SPL_FIT_SIGNATURE=y
|
|
CONFIG_SPL_LOAD_FIT=y
|
|
# CONFIG_BOOTMETH_VBE is not set
|
|
CONFIG_LEGACY_IMAGE_FORMAT=y
|
|
CONFIG_DEFAULT_FDT_FILE="rockchip/rk3588-jaguar.dtb"
|
|
# CONFIG_DISPLAY_CPUINFO is not set
|
|
CONFIG_DISPLAY_BOARDINFO_LATE=y
|
|
CONFIG_CYCLIC=y
|
|
CONFIG_SPL_MAX_SIZE=0x40000
|
|
CONFIG_SPL_BOARD_INIT=y
|
|
# CONFIG_SPL_RAW_IMAGE_SUPPORT is not set
|
|
CONFIG_SPL_ATF=y
|
|
# CONFIG_BOOTM_NETBSD is not set
|
|
# CONFIG_BOOTM_PLAN9 is not set
|
|
# CONFIG_BOOTM_RTEMS is not set
|
|
# CONFIG_BOOTM_VXWORKS is not set
|
|
# CONFIG_CMD_ELF is not set
|
|
CONFIG_CMD_ERASEENV=y
|
|
CONFIG_CMD_ADC=y
|
|
CONFIG_CMD_GPIO=y
|
|
CONFIG_CMD_GPT=y
|
|
CONFIG_CMD_I2C=y
|
|
# CONFIG_CMD_LOADB is not set
|
|
# CONFIG_CMD_LOADS is not set
|
|
CONFIG_CMD_MMC=y
|
|
CONFIG_CMD_PCI=y
|
|
# CONFIG_CMD_SF is not set
|
|
CONFIG_CMD_USB=y
|
|
# CONFIG_CMD_SETEXPR is not set
|
|
# CONFIG_CMD_MII is not set
|
|
# CONFIG_CMD_BLOCK_CACHE is not set
|
|
# CONFIG_CMD_EFICONFIG is not set
|
|
CONFIG_CMD_PMIC=y
|
|
CONFIG_CMD_REGULATOR=y
|
|
CONFIG_CMD_EROFS=y
|
|
CONFIG_CMD_SQUASHFS=y
|
|
# CONFIG_SPL_DOS_PARTITION is not set
|
|
CONFIG_SPL_OF_CONTROL=y
|
|
CONFIG_OF_LIVE=y
|
|
CONFIG_OF_SPL_REMOVE_PROPS="interrupt-parent assigned-clocks assigned-clock-rates assigned-clock-parents"
|
|
CONFIG_ENV_OVERWRITE=y
|
|
CONFIG_ENV_IS_IN_MMC=y
|
|
CONFIG_ENV_RELOC_GD_ENV_ADDR=y
|
|
CONFIG_SPL_DM_SEQ_ALIAS=y
|
|
CONFIG_SPL_REGMAP=y
|
|
CONFIG_SPL_SYSCON=y
|
|
CONFIG_BUTTON=y
|
|
CONFIG_BUTTON_ADC=y
|
|
CONFIG_SPL_CLK=y
|
|
CONFIG_CLK_GPIO=y
|
|
CONFIG_ROCKCHIP_GPIO=y
|
|
CONFIG_SYS_I2C_ROCKCHIP=y
|
|
CONFIG_MISC=y
|
|
CONFIG_SUPPORT_EMMC_RPMB=y
|
|
CONFIG_MMC_IO_VOLTAGE=y
|
|
CONFIG_SPL_MMC_IO_VOLTAGE=y
|
|
CONFIG_MMC_UHS_SUPPORT=y
|
|
CONFIG_SPL_MMC_UHS_SUPPORT=y
|
|
CONFIG_MMC_HS400_ES_SUPPORT=y
|
|
CONFIG_SPL_MMC_HS400_ES_SUPPORT=y
|
|
CONFIG_MMC_HS400_SUPPORT=y
|
|
CONFIG_SPL_MMC_HS400_SUPPORT=y
|
|
CONFIG_MMC_DW=y
|
|
CONFIG_MMC_DW_ROCKCHIP=y
|
|
CONFIG_MMC_SDHCI=y
|
|
CONFIG_MMC_SDHCI_SDMA=y
|
|
CONFIG_MMC_SDHCI_ROCKCHIP=y
|
|
# CONFIG_SPI_FLASH is not set
|
|
CONFIG_PHY_MICREL=y
|
|
CONFIG_PHY_MICREL_KSZ90X1=y
|
|
CONFIG_DWC_ETH_QOS=y
|
|
CONFIG_DWC_ETH_QOS_ROCKCHIP=y
|
|
CONFIG_NVME_PCI=y
|
|
CONFIG_PCIE_DW_ROCKCHIP=y
|
|
CONFIG_PHY_ROCKCHIP_INNO_USB2=y
|
|
CONFIG_PHY_ROCKCHIP_NANENG_COMBOPHY=y
|
|
CONFIG_SPL_PINCTRL=y
|
|
CONFIG_DM_PMIC=y
|
|
CONFIG_PMIC_RK8XX=y
|
|
CONFIG_REGULATOR_RK8XX=y
|
|
CONFIG_SPL_RAM=y
|
|
CONFIG_SCSI=y
|
|
CONFIG_DEBUG_UART_SHIFT=2
|
|
CONFIG_SYS_NS16550_MEM32=y
|
|
CONFIG_ROCKCHIP_SPI=y
|
|
CONFIG_SYSRESET=y
|
|
CONFIG_USB=y
|
|
CONFIG_USB_EHCI_HCD=y
|
|
CONFIG_USB_EHCI_GENERIC=y
|
|
CONFIG_USB_OHCI_HCD=y
|
|
CONFIG_USB_OHCI_GENERIC=y
|
|
CONFIG_FS_EXFAT=y
|
|
CONFIG_ERRNO_STR=y
|